XGETBV — Get Value of Extended Control Register
| Opcode | Instruction | Op/En | 64-Bit Mode | Compat/Leg Mode | Description |
|---|---|---|---|---|---|
| NP 0F 01 D0 | XGETBV | ZO | Valid | Valid | Reads an XCR specified by ECX into EDX:EAX. |
Instruction Operand Encoding ¶
| Op/En | Operand 1 | Operand 2 | Operand 3 | Operand 4 |
|---|---|---|---|---|
| ZO | N/A | N/A | N/A | N/A |
Description ¶
Reads the contents of the extended control register (XCR) specified in the ECX register into registers EDX:EAX. (On processors that support the Intel 64 architecture, the high-order 32 bits of RCX are ignored.) The EDX register is loaded with the high-order 32 bits of the XCR and the EAX register is loaded with the low-order 32 bits. (On processors that support the Intel 64 architecture, the high-order 32 bits of each of RAX and RDX are cleared.) If fewer than 64 bits are implemented in the XCR being read, the values returned to EDX:EAX in unimplemented bit locations are undefined.
XCR0 is supported on any processor that supports the XGETBV instruction. If CPUID.(EAX=0DH,ECX=1):EAX.XG1[bit 2] = 1, executing XGETBV with ECX = 1 returns in EDX:EAX the logicalAND of XCR0 and the current value of the XINUSE state-component bitmap. This allows software to discover the state of the init optimization used by XSAVEOPT and XSAVES. See Chapter 13, “Managing State Using the XSAVE Feature Set‚” in Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1.
Use of any other value for ECX results in a general-protection (#GP) exception.
Operation ¶
EDX:EAX := XCR[ECX];
Flags Affected ¶
None.
Intel C/C++ Compiler Intrinsic Equivalent ¶
XGETBV unsigned __int64 _xgetbv( unsigned int);
Protected Mode Exceptions ¶
| #GP(0) | If an invalid XCR is specified in ECX (includes ECX = 1 if CPUID.(EAX=0DH,ECX=1):EAX.XG1[bit 2] = 0). |
| #UD | If CPUID.01H:ECX.XSAVE[bit 26] = 0. |
| If CR4.OSXSAVE[bit 18] = 0. | |
| If the LOCK prefix is used. |
Real-Address Mode Exceptions ¶
| #GP(0) | If an invalid XCR is specified in ECX (includes ECX = 1 if CPUID.(EAX=0DH,ECX=1):EAX.XG1[bit 2] = 0). |
| #UD | If CPUID.01H:ECX.XSAVE[bit 26] = 0. |
| If CR4.OSXSAVE[bit 18] = 0. | |
| If the LOCK prefix is used. |
Virtual-8086 Mode Exceptions ¶
Same exceptions as in protected mode.
Compatibility Mode Exceptions ¶
Same exceptions as in protected mode.
64-Bit Mode Exceptions ¶
Same exceptions as in protected mode.